Automatic Irrigation DIY Kit Self Watering System with Capacitive Soil Moisture Sensor 1 Channel 5V Relay Module and Water Pump + 1M Vinyl Tubing ...

I bought this for a home project, but almost all of it was unusable, aside from the moisture sensor. it came with two pumps and a 5V relay. I set up the relay and plugged everything in, and the relay doesn't have power. But those are only a couple of dollars, so they're easily replaceable. I decided to check out the pumps they gave individually, and lo and behold, neither of those is operational either. Complete waste of money.

The directions are a bit confusing for someone who is an amateur at Arduino, but they can be figured out with some google searches and common sense. The code provided has a few errors in it, so here is the code that worked for me. One can just copy and paste it into the Arduino IDE. const int relayPin = 2; const int sensorPin = A0; float sensorValue = 0; void setup() { // put your setup code here, to run once: Serial.begin(9600); //begins communication with serial monitor pinMode(relayPin, OUTPUT); //sets pin 2 to output pinMode(sensorPin, INPUT); //sets pin A0 to input digitalWrite(relayPin, HIGH); //turns on relay, in turn turning on pump delay(500); //runs pump for 1/2 second } void loop() { // put your main code here, to run repeatedly: Serial.print("MOISTURE LEVEL: "); //prints "MOISTURE LEVEL: " sensorValue = analogRead(sensorPin); //sets "sensorValue" to input value from A0 Serial.print(sensorValue); //prints moisture level if(sensorValue>750) { digitalWrite(relayPin, HIGH); //if moisture level is above 750, turns off pump } else { digitalWrite(relayPin, LOW); //if moisture level is not above 750, turns on pump } Serial.println(); //prints new line for spacing delay(1000); //waits 1 second before re-checking moisture level } //Remember to select "tools>board" and "tools>port" before uploading code

1. I hope I can help someone who cannot read Chinese :-) The relay pins are marked in Chinese only! Here is the mapping (NO) (COM) (NC) 2. The water pump didn't work in the beginning. Later, I touched it and knocked it and it starts to work. I am afraid it is low quality and may be on/off from time to time and may quickly fail.The water pump wire is too thin and is very hard to connect to power and relay.

This is the best kit for this on ZeeBooth. Great price all the parts worked. This is great from someone that just got into audrino and got through some of the tutorials for coding. Remeber you need a Uno or equivalent to get this work also you need the wires to hook this all up.(usually provided in other kits, I have a ton) Audrino is very flexable so you can set this up multiple different ways. I used a breadboard but you can set it up without it. 10-15 Lines of code and had this up and running. Great seller, great price, fast shipping. I only have good things to say about this. Update: This is the best parts kit on ZeeBooth for working parts to get this work.If you don't know how to code basic code in sketch don't buy this as this isn't for one that has no clue how to code in arduino at all. This is for people that need the parts in a convenient listing i am a novice. There is no tutorial hand holding for the code side. This is for people that can figure out basic code and pins(plenty of videos) You can ignore the reviews by people saying no instructions as they have no idea what they bought. They wanted the seller to provide the code to pull this off which is not what they listed as it depends on the parts they already own. Anyway this kit is prefect because they sent me all working parts, if your complaining about anything else its your fault. Great seller.

Bought for a class project great for beginners