PL259 Coax Connectors, 5 Pack PL-259 UHF Male Solder Connectors with UG-175 Reducer Teflon Material for RG-58, RG-213, LMR195, RG142...

I like the connectors, made of quality material

Easy enough to solder the tip, and the shielding is tightly held by the course screw in of the base. I tried to solder the base, but even with a 200 watt iron I couldn't get it warm enough. I suppose I could use a small torch, but I think I'm at the point of diminishing returns by soldering it anyway, as the sheilding brade of the coax is tightly held. I checked it on the SWR analyzer, and I have a 1:1.059 SWR at 146.500 mhz, so this connector is not adding any appreciable impedance by not soldering the braid to the base. I've wiggled the heck out of it and tried to see if it would change or differ because I didn't solder it, and it was rock steady. I used both an swr swing-needle meter, as well as a VNA, and got the same great results. I'm happy with it, it should work well for a long time to come. Excellent connector!

They for here just as expected in time as described. Use them for antennas

Ease installation, good quality. I Have ordered from this seller three times because these connectors are good.

These seem to have a plating that is difficult to solder to - you will neeed to take a file and roughen the surface before soldering the shield - the center pin has a gold plating and readily accepts solder. Otherwise it appears well made and I prefer the Teflon insulator.