GoSports Chew Champ Bully Stick Holder for Dogs - Securely Holds Bully Sticks to Help Prevent Choking - 6 in or 8 in Size...

I had purchased a different product that you stick the bully stick through that didn't have a way to tighten it. It seemed really secure - until my dog started using it. He had the ring off in no time after chewing the bully stick in half. So using it was worse than using nothing. After reading reviews that compared products, I decided to try this one. He's only used it once, but the stick is still firmly in place. It is heavy, but that's good because he'll chew on the mat where I put it instead of all over the house. Will definitely recommend this one.

I buy the 6" Bully sticks for my two small dogs. One is a maltese and the other is a Cockapoo both about 11- 13 lbs. CoCo the cockapoo loves her bully sticks so I was happy to see this bone got good reviews . Except that you cant return it . I bought it any way and had high hopes of it is the answer to her getting the last inch of bully stick. Well it worked once the last inch stayed in the bone and I was able to retieve it and throw it away . The second time I gave her one she got the last inch of bully stick out and chewed it or swallowed it but it wasn't there when she walked away from the bone . So this isn't really the answer . the once side of the bone screws down to hold the bully stick but it actually goes only so far and there is a small spot that if the bully stick is narrow at that end it wont hold it. so it needs to be a fat bully stick to make sure that screws down to hold it. It seemed to be holding it fine I pulled on it after i screwed it now to the bully stick but apparently it still didn't hold it she was able to wiggle it out . Disappointing . I had cranked screwed it down hard against the bully stick to ...

- **Safety is Key:** The Chew Champ Bully Stick Holder is my go-to solution for promoting my puppers' safety. It securely holds bully sticks, significantly reducing the risk of choking and ensuring a worry-free chewing experience. - **Built to Last:** I l

There are many variations of Bully Stick (BS) holders, and I couldn't decide between four of them that are all pretty similar. So, I decided to buy all four and try them out. Full disclosure, my testing was done only with 7" BS's, which naturally vary in diameter. All four holders are pretty good, but there are some differences worth considering. This is how I ranked them. #1 (GoSports [Red] - 5 stars): The best of the bunch. Due to the narrow oval shape of the opening, it's very easy to load the BS and get it aligned with the clamp, regardless of the diameter of the BS. The handle for the clamp is very large and easy to get a good grip to twist it down tight. The tip of the clamp has a flat surface, which makes it easy to get a good hold on the BS without having to align on the BS groove. The clamp also does not loosen or back-off once tightened. This all allows for minimal BS waste. The plastic material is very tough and holds up to gnawing that can happen after the BS is chewed down to the nub. It's a good size for my 65 lb. Lab to hold down with her paws when chewing the BS. Update - 6/18/24: I continue to be very happy with this BS holder, but a few times the BS was too small to clamp and hold it. What I found works well in this situation is to just put two of the small BS's in the holder at the same time and clamp them both down. This has worked well for the few times this happened, and my dog was very happy to get a little extra chew time. ;-) #2 (ChewEasy [Light blue] - 4 stars): Similar to #1, and works well, but what I like less about it is that the round vs oval opening makes it not quite as easy as #1 to get the BS aligned with the clamp. Although, this might be preferrable if the BS's you buy are really large in diameter. The clamp handle is smaller, so not quite as easy to tighten down as #1. With the ends of the holder being smaller, they're also easier to gnaw on by the dog. #3 (BoniVet [Green] - 3 stars): This one has the advantage of being able to screw the tip of the clamp all the way through the other side of the holder, which does allow for a tight clamp. However, I found I didn't really like the pointy clamp tips as much as the flat ones (like #1 and #2). With the pointy tips, you have to get it aligned with the groove of the BS to get a good hold, and that is not always easy with smaller diameter BS's. The other thing I didn't like about this one is that even after the clamp was tightened, it sort of loosened on its own. The narrow plastic parts around the holder opening also seem susceptible to gnawing damage, although I haven't used it enough to say if it's a real problem. #4 (Bow Wow Labs [Dark blue] - 3 stars): This was actually the first style I bought, but there was enough I didn't like about it, that it caused me to look at the others. As mentioned with #3, I don't care for the pointy clamp tip. The round opening versus oval is less desirable for small BS's but may be needed for larger ones. The clamp itself does not screw in far enough to completely close the gap, so some of the smaller diameter BS could not be tightly clamped down, and my dog was able to get them out and swallow the BS nub. This probably only happened <5% of the time, but it sort of defeats the purpose of the holder. Also, the clamp can only be adjusted with your fingers, not your whole hand, so it's a little harder to tighten and loosen than the others. The edges on the ends of the holder are hard, but easy to gnaw on. So, this model is probably OK for really large BS's, but I found it less useful for the smaller ones.