GASHER 2PCS Aluminum 3 Way 6 Port Pneumatic Manifold Air Distribution Block Splitter 1/4" Output Port 1/4" Supply Port...

These are sold in pairs and they are a good value. The threads were proper taper thread in all holes, and they sealed up well. I work in an Aerospace machine shop, so I have an eye for the quality of machined hardware. The threads were a little rough, like maybe they were using dull tooling. There were some burrs too, but nothing major. They worked and sealed up fine. These were just what I was looking for to do an air delivery system in my shop.

These are sold in pairs and they are a good value. The threads were proper taper thread in all holes, and they sealed up well. I work in an Aerospace machine shop, so I have an eye for the quality of machined hardware. The threads were a little rough, like maybe they were using dull tooling. There were some burrs too, but nothing major. They worked and sealed up fine. These were just what I was looking for to do an air delivery system in my shop.

The unit itself is a five star item. Very well machined and all the threads are patent. Not sure if this is an AISN mix-up or just an issue with the listing, as the set I ordered was to have four manifolds and only two were sent. That's fine for now - but check your order when it arrives to ensure you're getting what you thought you ordered. This is going to be put to use as an air broom, and the two manifolds will work well on either side of the floor surface to move water and debris. Overall, happy with the manifolds, and probably ought not deduct a star because of what may be a clerical error, but the order said four manifolds and only two came.

Definitely worth the money!! Threads good and holds air great!

There's not really much you can say about a air manifold. All the ports are the right size. The finish is consistent. Though the six ports on the top all had resistance at the same point when screwing in connections. All couplers seated fully. There was just more resistance once about 2/3rds of the way through the threads. Other than that not a single issue so far.