Parts Washer Brush with Hose- Wear Resistant Parts Cleaning Brush with 31 Inch Long Hose- Parts Cleaner Flow Through Replacement Brush for Parts C...

This replacement has a stiff bristle brush, which I prefer for cleaning. The hose has no markings, so I'm unsure if it's safe for non-water based solvents, which gets it a knock. It's easy to replace, but would be nice to know. The stepped end of the hose which connects to the pump is interesting. You can trim it down to what is probably the metric equivalent of 1/2", 3/8" or 1/4" depending on your setup. I'd buy it again knowing the limitations, and replacing the hose isn't difficult.

This replaced worn out version on my parts washer. Simple swap and gets the job done. Works better than a worn out brush.

40 years ago I used to work at Safety-Kleen, and nearly every one of the parts washers I serviced had a flow-through brush. Today, my own personal parts washer has lacked one. So I finally grabbed this one. It makes it so much easier cleaning a gear housing or various parts when you have solution flowing through the brush. This is well made with conical brush tips, and a nice long hose.

This is a pretty nice replacement brush. It is easy to add to the parts washer nozzle, I did use a hose clamp on it just for a little extra but with as low pressure as my machine pushes, that step isnt really necessary. I only with the hose was about 8-10 longer. It reaches most areas of my washer, but if I needed something on the far left where my basket sits Ill have to figure something else out. I use primarily diesel fuel in my tub as it doesnt hurt or dry out rubber seals, and its cheaper per gallon than anything else Ive found. Hopefully I get just as many years out of this brush as I did my other.

I have a parts washer and needed a new brush, I was surprised at the heftiness and feel of this brush, very nice addtion to my parts washer.